詳細(xì)說(shuō)明：
DYNASOLVE CU-7 樹脂溶解劑，電子溶解劑
Dynasolve CU-7 is a safer solvent used for removing polyimide coatings. It is used extensively in the fiber
optics industry.
General
Dynasolve CU-7 is a high flash point, proprietary solvent system designed to remove polyimide coatings from
various substrates. The product is a non-chlorinated, non-carcinogenic, non-ozone depleting solvent.
Dynasolve CU-7 can be used for extended periods without decomb.
Applications
1. Removal of polyimide coatings from fiber optics.
2. Removal of polyimide coatings from semiconductor wafers.
3. Removal of polyimide coatings from advanced composites and various bls.
Specifications
Color: Water white
Specific Gravity: 1.03
Boiling Point: >392oF
Flash Point: 204°F (Lowest flashing component)
Directions For Use
1. Immerse material with polyimide coating into a glass or bl container, preferably stainless steel.
2. Heat for 10 minutes – 2 hours at 180-380oF. Polyimide films can differ greatly in both comb and
degree of curing and therefore a very broad beter recommendation is required.
3. Use of ultrasonic cleaners or mechanical mixing of the solvent will speed up the removal rate.
4. The solvent works by breaking the bond between the polyimide and the substrate permitting removal of the
polyimide as a film.
5. Rinse substrate with alcohol or water and dry.
Caution and Warnings
Dynasolve CU-7 contains powerful organic solvents. It is harmful if inhaled or swallowed. Avoid breathing
vapors or mist. Keep away from heat and flame. Avoid contact with eyes and skin. Wear gloves, safety
goggles, and protective clothing when handling. Use with adequate ventilation. Refer to MSDS before use, for
disposal, or additional safe handling.
