AONE/A-ONE AUTOVALVE,AD65-50F 50A 2″查看全部中山立訊電氣有限公司直銷中山立訊電氣有限公司銷售韓國DONGYANG F&C 氫氧化鈉自動閥
等等，若需了解詳細的資料，歡迎留言公司網站或來電垂詢！！
DONGYANG F&C 氫氧化鈉自動閥
BCS-1000S BCS-1100S BCS-1200S BCS-1300S BCS-1400S BCS-1500S
BCS-2000S BCS-2100S BCS-2200S BCS-2300S BCS-2400S BCS-2500S
BCS-3000S BCS-3100S BCS-3200S BCS-3300S BCS-3400S BCS-3500S
BCS-1010S BCS-1110S BCS-1210S BCS-1310S BCS-1410S BCS-1510S
BCS-2010S BCS-2110S BCS-2210S BCS-2310S BCS-2410S BCS-2510S
BCS-3010S BCS-3110S BCS-3210S BCS-3310S BCS-3410S BCS-3510S
BCS-1020S BCS-1120S BCS-1220S BCS-1320S BCS-1420S BCS-1520S
BCS-2020S BCS-2120S BCS-2220S BCS-2320S BCS-2420S BCS-2520S
BCS-3020S BCS-3120S BCS-3220S BCS-3320S BCS-3420S BCS-3520S
BCS-1001S BCS-1101S BCS-1201S BCS-1301S BCS-1401S BCS-1501S
在電場中任一點處，取一塊面積元，與該點場強的方向相垂直，我們把場強大小與面積元之乘積，稱為穿過該面積元的電通量，用表示，即=根據電力線數目和電場強度之間的關系：這樣，我們把穿過電場中任一個給定面積S的電通量就可以用通過該面積的電場線條數來表述?！ ‰妱?dòng)機輸出功率很低時，所消耗的有功功率，但是所需要的無功功率基本不變，所以無功功率所占比例增大，電動機的COS￠就更低，甚至低于0.5。因此，對于發電廠來說，就必須在輸出有功功率的同時，也輸出無功功率，在輸出的總功率中，有功功率和無功功率各占多少，不是決定于發電機，而是取決于負荷的需要，即取決于負荷的功率因數。 最小負載電流（單位：mA）：固態繼電器執行規定工作所必須的最小負載電流。它一般與最大負載電流一并作為“工作電流范圍”列出。最大負載電流（單位：A）：在規定的環境溫度下，固態繼電器的最大穩態負載電流能力，它還受散熱器和環境溫度條件的散熱限制。
BCS-2001S BCS-2101S BCS-2201S BCS-2301S BCS-2401S BCS-2501S
BCS-3001S BCS-3101S BCS-3201S BCS-3301S BCS-3401S BCS-3501S
BCS-1011S BCS-1111S BCS-1211S BCS-1311S BCS-1411S BCS-1511S
BCS-2011S BCS-2111S BCS-2211S BCS-2311S BCS-2411S BCS-2511S
BCS-3011S BCS-3110S BCS-3211S BCS-3311S BCS-3411S BCS-3511S
BCS-1021S BCS-1121S BCS-1221S BCS-1321S BCS-1421S BCS-1521S
BCS-2021S BCS-2121S BCS-2221S BCS-2321S BCS-2421S BCS-2521S
BCS-3021S BCS-3121S BCS-3221S BCS-3321S BCS-3421S BCS-3521S
造成非輻射復合(產生熱量)，從而降低LED的內量子效率,溫度升高導致芯片的藍光波峰向長波方向偏移，使芯片的發射波長和熒光粉的激發波長不匹配，也會造成白光LED外部光提取效率的降低,同時隨著溫度上升，熒光粉量子效率降低。
BCS-1002S BCS-1102S BCS-1202S BCS-1302S BCS-1402S BCS-1502S
BCS-2002S BCS-2102S BCS-2202S BCS-2302S BCS-2402S BCS-2502S
BCS-3002S BCS-3102S BCS-3202S BCS-3302S BCS-3402S BCS-3502S
BCS-1012S BCS-1112S BCS-1212S BCS-1312S BCS-1412S BCS-1512S
BCS-2012S BCS-2112S BCS-2212S BCS-2312S BCS-2412S BCS-2512S
BCS-3012S BCS-3110S BCS-3212S BCS-3312S BCS-3412S BCS-3512S
BCS-1022S BCS-1122S BCS-1222S BCS-1322S BCS-1422S BCS-1522S
BCS-2022S BCS-2122S BCS-2222S BCS-2322S BCS-2422S BCS-2522S
BCS-3022S BCS-3122S BCS-3222S BCS-3322S BCS-3422S BCS-3522S
BCS-1003S BCS-1103S BCS-1203S BCS-1303S BCS-1403S BCS-1503S
BCS-2003S BCS-2103S BCS-2203S BCS-2303S BCS-2403S BCS-2503S
BCS-3003S BCS-3103S BCS-3203S BCS-3303S BCS-3403S BCS-3503S
可不同檔位的開關，轉換開關由多層絕緣殼體組裝而成，可立體布置，減小了安裝面積，結構簡單，緊湊，操作可靠，轉換開關可以按線路的要求組成不同接法的開關，以適應不同電路的要求，在控制和測量系統中，采用轉換開關可進行電路的轉換。
BCS-1013S BCS-1113S BCS-1213S BCS-1313S BCS-1413S BCS-1513S
BCS-2013S BCS-2113S BCS-2213S BCS-2313S BCS-2413S BCS-2513S
BCS-3013S BCS-3110S BCS-3213S BCS-3313S BCS-3413S BCS-3513S
BCS-1023S BCS-1123S BCS-1223S BCS-1323S BCS-1423S BCS-1523S
2．電氣性能校驗及：a.動作電壓：在70％額定電壓下沖擊地加電壓于繼電器線圈，此時繼電器應可靠地動作，若動作電壓過高，應檢查塔形彈簧彈力是否過強，唧子在黃銅管內是否較大，瞬動動合觸點壓力是否過大，應瞬動觸點壓力，以便達到動作電壓。
BCS-2023S BCS-2123S BCS-2223S BCS-2323S BCS-2423S BCS-2523S
BCS-3023S BCS-3123S BCS-3223S BCS-3323S BCS-3423S BCS-3523S
BCS-1004S BCS-1104S BCS-1204S BCS-1304S BCS-1404S BCS-1504S
BCS-2004S BCS-2104S BCS-2204S BCS-2304S BCS-2404S BCS-2504S
BCS-3004S BCS-3104S BCS-3204S BCS-3304S BCS-3404S BCS-3504S
BCS-1014S BCS-1114S BCS-1214S BCS-1314S BCS-1414S BCS-1514S
BCS-2014S BCS-2114S BCS-2214S BCS-2314S BCS-2414S BCS-2514S
BCS-3014S BCS-3110S BCS-3214S BCS-3314S BCS-3414S BCS-3514S
BCS-1024S BCS-1124S BCS-1224S BCS-1324S BCS-1424S BCS-1524S
BCS-2024S BCS-2124S BCS-2224S BCS-2324S BCS-2424S BCS-2524S
BCS-3024S BCS-3124S BCS-3224S BCS-3324S BCS-3424S BCS-3524S
根據線圈中電流的大小而接通和斷開電路的繼電器稱為電流繼電器。使用時電流繼電器的線圈與負載串聯，其線圈的匝數少而線徑粗。常用的有欠電流繼電器和過電流繼電器兩種。欠電流繼電器：電路正常工作時，欠電流繼電器吸合，當電路電流減小到某一整定值以下時(10％～20％IN)，欠電流繼電器釋放，對電路實現欠電流保護?！ 〗涣髌鞴ぷ髟恚寒?dāng)電磁線圈接受指令信 得電后，鐵心被磁化為電磁鐵，產生電磁吸力，當克服彈簧的反彈力時使動鐵心吸合，帶動觸頭動作，即常閉觸頭分開、常開觸頭閉合；當線圈失電后，電磁鐵失磁，電磁吸力消失，在彈簧的作用下觸頭復位。
